M30×2 thread

M30×2 is a fine metric thread with a 30 mm (1.181") major diameter and 2 mm pitch. Tap it with a 28 mm drill; drill 31 mm to pass a bolt through.

The numbers

Designation

M30×2

Major diameter

30 mm / 1.181"

Minor diameter

27.835 mm

Pitch

2 mm pitch

Tap drill (75% thread)

28 mm — 28 mm

Clearance hole (close fit)

31 mm / 1.220"

Hex across flats

46 mm

How to measure what you have

1. Measure across the thread crests with calipers. A used M30×2 reads a little under 30 mm — the crests are truncated by the standard, then worn and plated, so anything from about 29.6 mm up is consistent with this size.
2. Measure the pitch: put a rule against the threads and count the distance over ten crests, then divide by ten. This one should give 2 mm.
3. A thread pitch gauge settles it in seconds and costs very little. Guessing between a coarse and a fine thread of the same diameter is the usual way a thread gets stripped.

Tightening torque

Plain steel property class 8.8 or SAE grade 5, dry threads, tightened to about 65% of yield. Lubricated threads reach the same preload at 20-30% less torque. Where the manufacturer publishes a figure — spark plugs, wheel nuts, cylinder heads — use theirs.

Where this size turns up

• Large machine spindle and bearing lock nuts
• Heavy hydraulic cylinder rod ends

Other threads at this diameter